logitech alert commander smtp stop working

#Logitech alert commander smtp stop working software#

You won’t ever know the mail was sent to you.Įudora places SPAM in the “Junk” folder.

If you are not receiving any alert messages, and you don’t see a Junk Mail folder, your spam filter may be set to “Aggressive Spam Sentry Junk Mail Filter.” Any mail sent to you that is not from email addresses in your address book is immediately destroyed. To get alert messages to display in the Inbox, add the outgoing mail server name (i.e. If Commander’s alert messages are not displaying in the Inbox, check the “Junk Mail” folder. With Standard Spam Sentry Junk Mail Filter activated, EarthLink places SPAM in the “Junk Mail” folder. If Commander’s alert messages get placed in either of these folders, they can be easily accepted as non-spam by opening either folder, clicking in the checkbox next to the alert message, and going to the Checked Items dropdown field and selecting the option “Move to Inbox & Add Contact.”ĮarthLink has two spam filter options available for 5.0– Standard Spam Sentry Junk Mail Filter and Aggressive Spam Sentry Junk Mail Filter. When this is activated, spam email is placed in either the “Known Spam” or “Suspect Email” folders. If Commander’s alert messages get placed in the SPAM folder, you can move them to the Inbox by clicking on the checkbox next to the alert message, and then clicking on the “This is Not Spam” button at the top of the message list.īoth Total Access and Web Mail use EarthLink’s spamBlocker tool. If your email provider is not listed below, google your mail service on an Internet browser and locate spam options in the Help or Options documentation on the email provider’s website.ĪOL places SPAM and junk mail automatically in the “SPAM” folder. Unfortunately, these instructions do not cover every email service. These instructions assist you with unblocking alert emails. We’ve included instructions for some of the more popular email systems. Note: If our alert emails are not appearing in these locations, contact your provider to troubleshoot further. Locate and open the SPAM folder (or Junk E-Mail, Bulk, or a similar name), if you feel that our emails are being blocked. Close and restart the Alert Commander software.If you are not receiving alert emails from the Commander, it may be due to your email service blocking the emails because it considers them to be spam.

#Logitech alert commander smtp stop working software#

Purple LED – This means camera is connected to the Alert Commander software but not the internet. If the camera works on this outlet, there is a problem with the electrical line where the camera was previously connected. Connect the camera to a power outlet where an existing camera is working properly.Remove any passwords previously assigned in Alert Commander.Close the Logitech Alert Commander software.Do the following to troubleshoot the problem:

Yellow LED – This usually means the camera is unable to obtain an IP address from the router or DHCP server. If the LED stays red after the power cycle, the camera may need to be replaced.

Use the camera’s pin hole to reset it and let it perform a power cycle.

Red LED – This indicates that camera boot-up has failed. If the LED stays white after you perform these steps, the camera is most likely defective. However, if the LED stays white, please do the following: White LED – In most cases, this indicates that the camera is performing a power cycle.

Close the Alert Commander software and then restart it.

Green LED – The camera is connected to the internet, but not to Alert Commander: MicroSD card read/write failure - No microSD card Not connected to Alert Commander or internet If you cannot get it to go past this by doing a hard reset several times, then the camera may need to be replaced.Ĭonnected to Alert Commander and internet System is booting up (may take up to 90 seconds)Ĭamera boot-up failed. Your Alert security camera has a status LED to let you know what is going on with it.